NXP Semiconductors
PCU9955
16-channel UFm I 2 C-bus 57 mA constant current LED driver
2. Features and benefits
? 16 LED drivers. Each output programmable at:
? Off
? On
? Programmable LED brightness
? Programmable group dimming/blinking mixed with individual LED brightness
? Programmable LEDn output enable delay to reduce EMI and surge currents
? 16 constant current output channels can sink up to 57 mA, tolerate up to 40 V when
OFF
? Output current adjusted through an external resistor
? Output current accuracy
? ? 6 % between output channels
? ? 8 % between PCU9955 devices
? Thermal shutdown for overtemperature
? 5 MHz Ultra Fast-mode compatible I 2 C-bus interface
? 256-step (8-bit) linear programmable brightness per LEDn output varying from fully off
(default) to maximum brightness using a 31.25 kHz PWM signal
? 256-step group brightness control allows general dimming (using a 122 Hz PWM
signal) from fully off to maximum brightness (default)
? 256-step group blinking programmable from 15 Hz to 16.8 s and duty cycle from 0 %
to 99.6 %
? Output state change programmable on the Acknowledge (bit 9, this bit is always set
to 1 by I 2 C-bus master) or the STOP Command to update outputs byte-by-byte or all at
the same time (default to ‘Change on STOP’).
? 4 hardware address pins allow 16 PCU9955 devices to be connected to the same
I 2 C-bus and to be individually programmed
? 4 software programmable I 2 C-bus addresses (one LED Group Call address and three
LED Sub Call addresses) allow groups of devices to be addressed at the same time in
any combination (for example, one register used for ‘All Call’ so that all the PCU9955s
on the I 2 C-bus can be addressed at the same time and the second register used for
three different addresses so that 1 ? 3 of all devices on the bus can be addressed at the
same time in a group). Software enable and disable for each programmable I 2 C-bus
address.
? Unique power-up default Sub Call address allows mixing of devices with different
channel widths
? Software Reset feature (SWRST Call) allows the device to be reset through the
I 2 C-bus
? 8 MHz internal oscillator requires no external components
? Internal power-on reset
? Noise filter on USDA/USCL inputs
? No glitch on LEDn outputs on power-up
? Low standby current
? Operating power supply voltage (V DD ) range of 3 V to 5.5 V
? 5.5 V tolerant inputs on non-LED pins
? ? 40 ? C to +85 ? C operation
PCU9955
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 2 — 2 October 2012
? NXP B.V. 2012. All rights reserved.
2 of 39
相关PDF资料
PDA006B-700C LED DRIVER 6W 700MA
PDA010B-700C LED DRIVER 8.4W 700MA
PDA015B-350C LED DRIVER 15W 350MA
PDA030B-700C LED DRIVER 30W 700MA
PDC500-1024F SINGLE OUTPUT 500W 24V
PDU1215 POWER STRIP 15A 13 OUT RACK M
PDU1220T POWER STRIP 20A 13 OUT RACK MNT
PDU1220 POWER STRIP 20A 13 OUT RACK MNT
相关代理商/技术参数
PCU9956ATWY 制造商:NXP Semiconductors 功能描述:PCU9956ATW/HTSSOP38/REEL13DP// - Tape and Reel 制造商:NXP Semiconductors 功能描述:IC LED DVR PWM CTLR 38HTSSOP
PCUA30 制造商:HONEYWELL-ACC 制造商全称:Honeywell Accelerometers 功能描述:ULTRASONIC PROXIMITY SENSORS
PCUA30M30AI 功能描述:ULTRASONIC SENSOR 30" 4-20MA RoHS:是 类别:传感器,转换器 >> 超声波接收器/发射器 系列:- 标准包装:1 系列:- 频率:215kHz 带宽:- 发射灵敏度:- 接收灵敏度:- 电压 - 额定:10 ~ 30VDC 射束角:10° 包装:*
PCUA30M30AV 功能描述:ULTRASONIC SENSOR 30" 0-5V RoHS:是 类别:传感器,转换器 >> 超声波接收器/发射器 系列:- 标准包装:1 系列:- 频率:215kHz 带宽:- 发射灵敏度:- 接收灵敏度:- 电压 - 额定:10 ~ 30VDC 射束角:10° 包装:*
PCUA30M30-AV 功能描述:ULTRASONIC SENSOR 30" 0-5V RoHS:是 类别:传感器,转换器 >> 超声波接收器/发射器 系列:- 标准包装:1 系列:- 频率:215kHz 带宽:- 发射灵敏度:- 接收灵敏度:- 电压 - 额定:10 ~ 30VDC 射束角:10° 包装:*
PCUA30M30NA 功能描述:ULTRASONIC SENSOR 30" NO RoHS:是 类别:传感器,转换器 >> 超声波接收器/发射器 系列:- 标准包装:1 系列:- 频率:215kHz 带宽:- 发射灵敏度:- 接收灵敏度:- 电压 - 额定:10 ~ 30VDC 射束角:10° 包装:*
PCUA30M30NB 制造商:Honeywell Sensing and Control 功能描述:Proximity Sensor Ultrasonic NC 76cm 10V to 30V 2-Pin
PCUA30M30PA 功能描述:ULTRASONIC SENSOR 30" NO RoHS:是 类别:传感器,转换器 >> 超声波接收器/发射器 系列:- 标准包装:1 系列:- 频率:215kHz 带宽:- 发射灵敏度:- 接收灵敏度:- 电压 - 额定:10 ~ 30VDC 射束角:10° 包装:*